Toyota Corolla Quiz
Automatic transmission / trans

Shift lock system (atm)

In this manual: Automatic transmission / trans
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
10steps
~60min
3/5difficulty
Done 0 of 10
On–vehicle inspection 1. Check shift lock operation
  1. shift the shift lever to p position.
  2. turn the ignition switch to lock.
  3. check that the shift lever cannot be shifted to any other positions other than p.
  4. turn the ignition switch to on, depress the brake pedal and check that the shift lever can be shifted to any other positions.
2. Check shift lock release button operation
  1. using a screwdriver, remove the shift lock release button cover.
  2. when operating the shift lever with the shift lock release button pressed and the ignition key in acc or on, check that the lever can be shifted to any other positions.
3. Check key interlock operation
  1. turn the ignition switch to on.
  2. depress the brake pedal and shift the shift lever to any other positions other than p.
  3. check that the ignition key cannot be turned to lock.
  4. shift the shift lever to p position, turn the ignition key to lock and check that the ignition key can be removed.
4. Inspect shift lock control ecu
Toyota Corolla. Inspect shift lock control ecu
  1. Using a voltmeter, measure the voltage at each terminal.
Hint

: do not disconnect the shift lock control ecu connector.
Toyota Corolla. Inspect shift lock control ecu
  1. Using an ohmmeter, measure the resistance at terminal e (1) and body ground.
Floor shift assy (atm)

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.