Toyota Corolla Quiz
Automatic transmission / trans

Front differential oil seal

In this manual: Automatic transmission / trans
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
8steps
~48min
2/5difficulty
Done 0 of 8
Replacement 1. Drain manual transaxle oil

torque: 39.2 Nvm (400 Kgf·cm, 29 ft·lbf)

2. Remove front wheels 3. Remove engine under cover lh 4. Remove engine under cover rh 5. Drain transaxle oil 6. Remove front drive shaft assy lh

sst 09520–01010, 09520–24010 (09520–32040)

7. Remove front drive shaft assy rh

sst 09520–01010, 09520–24010 (09520–32040)

8. Remove transaxle case oil seal
Toyota Corolla. Remove transaxle case oil seal
  1. Using sst, remove the transaxle case oil seal.

    Sst 09308–00010

9. Remove transmission case oil seal
Toyota Corolla. Remove transmission case oil seal
  1. Using sst, remove the transmission case oil seal.

    Sst 09308–00010

10. Install transaxle case oil seal
Toyota Corolla. Install transaxle case oil seal
  1. Coat a new oil seal lip with mp grease.
  2. using sst and a hammer, install the transaxle case oil seal.

    Sst 09554–14010, 09950–70010 (09951–07200) drive in depth: 1.9 0.3 Mm (0.075 0.012 In.)

Notice

: be careful not to damage the oil seal lip.

 11. Install transmission case oil seal
Toyota Corolla. Install transmission case oil seal
  1. Coat a new oil seal lip with mp grease.
  2. using sst and a hammer, install the transmission case oil seal. Sst 09554–14010, 09950–70010 (09951–07200) drive in depth: 9.9 0.3 Mm (0.390 0.012 In.) Notice

    : be careful not to damage the oil seal lip.

  3. Install front drive shaft assy lh
  4. Install front drive shaft assy rh
  5. Install front wheels torque: 103 nvm (1,050 Kgf·cm, 76 ft·lbf)
  6. Add manual transaxle oil
    Toyota Corolla. Install transmission case oil seal

Oil grade: api gl–4 or gl–5 viscosity: sae 75 w–90
capacity:1.9 Liters (2.0 Us qts, 1.7 Lmp. Qts) torque: 39.2 Nvm (400 Kgf·cm, 29 ft·lbf)

16. Inspect and adjust manual transaxle oil 17. Inspect and adjust front wheel alignment 18. Check abs speed sensor signal

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.