Toyota Corolla Quiz
Automatic transmission / trans

Front differential oil seal (atm)

In this manual: Automatic transmission / trans
Introduction — 31Preparation — 32Service specifications — 19Diagnostics — 497Engine control system — 6Fuel — 13Emission control — 28Exhaust — 3Cooling — 13Lubrication — 7Ignition — 3Starting & charging — 13Front suspension — 12Rear suspension — 9Tire & wheel — 1Drive shaft / propeller shaft — 15Brake — 42Automatic transmission / trans — 47Clutch — 19Steering column — 9Power steering — 11Heater & air conditioner — 20Supplemental restraint system — 27Seat belt — 12Lighting — 18Wiper & washer — 9Audio & visual — 12Wiring — 1Communication system — 1Windshield/windowglass/mirror — 31Seat — 10Theft deterrent & door lock — 10Sliding roof/convertible — 8Engine hood/door — 12Exterior/interior trim — 20Vehicle control system — 1Cruise control — 5Maintenance — 8
6steps
~36min
2/5difficulty
Done 0 of 6
Replacement 1. Remove front wheels 2. Remove engine under cover rh 3. Remove engine under cover lh 4. Drain automatic transaxle fluid
  1. remove the drain plug, gasket and drain atf.
  2. install a new gasket and drain plug.

    Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf)

5. Remove front drive shaft assy rh 6. Remove front drive shaft assy lh 7. Remove transaxle housing oil seal(rh)
Toyota Corolla. Remove transaxle housing oil seal(rh)
  1. Using sst, pull out the oil seal.

    Sst 09308–00010

8. Remove transaxle case oil seal(lh)
Toyota Corolla. Remove transaxle case oil seal(lh)
  1. Using sst, pull out the oil seal.

    Sst 09308–00010

9. Install transaxle housing oil seal(rh)
Toyota Corolla. Install transaxle housing oil seal(rh)
  1. Using sst and a hammer, drive in a new oil seal.

    Sst 09350–32014 (09351–32130, 09351–32150) oil seal drive in depth: 2.0 0.5 Mm (0.079 0.020 In.)

  2. coat the lip of the oil seal with mp grease.
10. Install transaxle case oil seal(lh)
Toyota Corolla. Install transaxle case oil seal(lh)
  1. Using sst and a hammer, drive in a new oil seal.

    Sst 09350–32014 (09351–32111, 09351–32130) oil seal drive in depth: 5.3 0.5 Mm (0.209 0.020 In.)

  2. coat the lip of the oil seal with mp grease.
11. Install front drive shaft assy lh 12. Install front drive shaft assy rh 13. Install engine under cover lh 14. Install engine under cover rh 15. Install front wheels

torque: 103 nvm (1050 Kgf·cm, 76 ft·lbf)

16. Add automatic transaxle fluid 17. Inspect automatic transaxle fluid 18. Inspect and adjust front wheel alignment 19. Check abs speed sensor signal (w/ abs)

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.