Brake
On–vehicle inspection
In this manual: Brake
10steps
~60min
3/5difficulty
Done 0 of 10
1. Inspect brake booster

Depress the brake pedal while the engine is running, and stop the engine with the pedal depressed. Hint

- Airtightness check.
- Start the engine and stop it after 1 or 2 minutes. Depress the brake pedal several times slowly.
: if the pedal goes down farthest at the 1st time, but gradually rises after the 2nd or 3rd time, the booster is airtight.
: if there is no change in the pedal reserve distance after holding the pedal for 30 seconds, the booster is airtight.

- Operating check.
- Depress the brake pedal several times with the ignition switch off and check that there is no change in the pedal reserve distance.
- Depress the brake pedal and start the engine.
: if the pedal goes down slightly, operation is normal.
2. Inspect vacuum check valve- check vacuum check valve.
- Slide the clip and disconnect the vacuum hose.
- Remove the vacuum check valve.

- Check that there is ventilation from the booster to engine, and no ventilation from the engine to the booster.
- If any fault is found, replace the vacuum check valve.
Test yourself
A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?