Toyota Land Cruiser Quiz
Propeller Shaft

Inspection

In this manual: Propeller Shaft
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read

NOTICE: Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.

1. INSPECT FRONT AND REAR PROPELLER SHAFTS FOR DAMAGE OR RUNOUT

INSPECT FRONT AND REAR PROPELLER SHAFTS FOR DAMAGE OR RUNOUT

Using a dial indicator, check the runout of shafts.

Maximum runout: 0.8 mm (0.031 in.)

If shaft runout is greater than maximum, replace the shaft.

2. INSPECT SPIDER BEARING

INSPECT SPIDER BEARING
(a) Check the spider bearings for wear or damage.

(b) Check the spider bearing axial play by turning the yoke with holding the shaft tightly.

Maximum bearing axial play: 0 mm (0 in.)

If necessary, replace the spider bearing.

INSTALLATION

Installation is in the reverse order of removal ( PR-4 ).

HINT: After installation, pump MP grease into each fitting with a grease gun until the grease begins to flow around the oil seal.

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.