Air conditioning control assembly (for automatic air conditioning system)

1. Disconnect cable from negative battery terminal

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

1. 1
   Remove no. 2 Instrument cluster finish panel center (see page ip-5)
2. 2
   Remove no. 1 Instrument cluster finish panel center (see page ip-5)
3. 3
   Remove radio receiver (see page ip-5)
4. 4
   Remove air conditioning control assembly

   

1. 1
   Remove the 2 screws.
2. 2
   Using a screwdriver, detach the 3 clips.

Tape the screwdriver tip before use.

3. Connect the connectors and remove the air conditioning control.

1. Install air conditioning control assembly

1. 1
   Install air conditioning control assembly
2. 2
   Connect the connectors.
3. 3
   Attach the 3 clips to install the air conditioning control.
4. 4
   Install the 2 screws.
5. 5
   Install radio receiver (see page ip-10)
6. 6
   Install no. 1 Instrument cluster finish panel center (see page ip-10)
7. 7
   Install no. 2 Instrument cluster finish panel center (see page ip-10)
8. 8
   Connect cable to negative battery terminal
9. 9
   Check srs warning light
10. 10
    Check the srs warning light (see page rs-37).