Air conditioning control assembly (for manual air conditioning system)

1. Disconnect cable from negative battery terminal

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

1. 1
   Remove no. 2 Instrument cluster finish panel center (see page ip-5)
2. 2
   Remove no. 1 Instrument cluster finish panel center (see page ip-5)
3. 3
   Remove radio receiver assembly (see page ip-5)
4. 4
   Remove air conditioning control assembly

   

1. 1
   Remove the 2 screws.
2. 2
   Using a screwdriver, detach the 3 clips.

Tape the screwdriver tip before use.

1. 1
   Disconnect the connectors and remove the air conditioning control.
2. 2
   Remove air mix control switch

   

1. 1
   Detach the 2 claws and remove the air mix control switch.
2. 2
   Remove blower control switch

   

1. 1
   Detach the 2 claws and remove the blower control switch.
2. 2
   Remove air vent mode control switch

   

1. Detach the 2 claws and remove the mode control switch.

1. 1
   Install air vent mode control switch
2. 2
   Attach the 2 claws to install the mode control switch.
3. 3
   Install blower control switch
4. 4
   Attach the 2 claws to install the blower control switch.
5. 5
   Install air mix control switch
6. 6
   Attach the 2 claws to install the air mix control switch.
7. 7
   Install air conditioning control assembly

   

1. 1
   Connect the connectors.
2. 2
   Attach the 3 clips to install the air conditioning control.
3. 3
   Install the 2 screws.
4. 4
   Install radio receiver assembly (w/ radio receiver) (see page ip-10)
5. 5
   Install no. 1 Instrument cluster finish panel center (see page ip-10)
6. 6
   Install no. 2 Instrument cluster finish panel center (see page ip-10)
7. 7
   Connect cable to negative battery terminal
8. 8
   Check srs warning light
9. 9
   Check the srs warning light (see page rs-37).