Brake rear brake flexible hose

• Use the same procedures for the lh side and rh side.
• The procedures listed below are for the lh side.

1. 1
   Remove rear wheel
2. 2
   Drain brake fluid

Wash off brake fluid immediately if it comes in contact with any painted surface.

1. 1
   Remove rear brake tube flexible hose
2. 2
   Disconnect the brake tube (labeled a) from the flexible hose with sst while holding the flexible hose with a wrench.

• Do not bend or damage the brake tube.
• Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

1. 1
   Remove the clip (labeled b).
2. 2
   Remove the union bolt and gasket(s), and then remove the flexible hose from the disc brake cylinder.

   

• Use the same procedures for the lh side and rh side.
• The procedures listed below are for the lh side.

1. Install rear disc brake cylinder assembly lh

1. Apply silicon grease (multemp si-b) on the contact surfaces of the cylinder parts indicated by the arrows.

1. 1
   Install the cylinder with the 2 bolts.
2. 2
   Connect rear flexible hose lh

   

The gasket and union bolt must be used as a set, as shown in the illustration.

1. Connect the flexible hose with new gasket(s) and the union bolt.

Install the flexible hose lock securely in the lock hole in the cylinder.

1. 1
   Fill reservoir with brake fluid (see page br- 6)
2. 2
   Bleed air from brake master cylinder (see page br-7)
3. 3
   Bleed air from brake line (see page br-7)
4. 4
   Bleed air from abs and traction actuator assembly (see page br-8)
5. 5
   Check brake fluid level in reservoir (see page br-6)
6. 6
   Check for brake fluid leakage
7. 7
   Install rear wheel torque: 103 n*m (1,050 kgf*cm, 76 ft.*Lbf)