Parking brake system

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

1. 1
   Check parking brake lever travel
2. 2
   Pull the lever upward with a force of approximately 200 n (20 kgf, 44 lbf) and count the number of clicks.

1. 1
   Remove upper rear console panel subassembly (see page ip-19)
2. 2
   Loosen lock nut and no. 1 Wire adjusting nut
3. 3
   Remove rear wheel
4. 4
   Adjust parking brake shoe clearance (see page pb-17)
5. 5
   Install rear wheel torque: 103 n*m (1,050 kgf*cm, 76 ft.*Lbf)

   

7. Adjust parking brake lever travel

1. Turn the no. 1 Wire adjusting nut until the lever travel is correct.

2. Tighten the lock nut.

4. When operating the parking brake lever, check that the brake warning light illuminates at the first click.