Front passenger side seat belt warning light malfunction

When the ignition switch is on, the center airbag sensor transmits front seat inner belt status signals to the combination meter through the can bus line. If the front passenger seat belt is not fastened, the heater control panel (automatic a/c) or clock (manual a/c) blinks the front passenger seat belt warning light. If the seat belt is fastened, the warning light goes off.

The seat belt warning system uses the can bus line. Before troubleshooting the seat belt warning system, perform "communication function check" by following "how to proceed with troubleshooting" to confirm that the communication systems are normal.

1. 1
   Perform active test by intelligent tester
2. 2
   Select the active test, use the intelligent tester to generate a control command, and then check that the seat belt warning light operates.

Center airbag sensor:

1. 1
   Check a/c type
2. 2
   Check system.

   

3. Check heater control panel (power source circuit)

1. 1
   Disconnect the e23 panel connector.
2. 2
   Measure the voltage and resistance of the wire harness side connector.

Standard voltage

Standard resistance

4. Check wire harness (heater control panel - combination meter assembly)

1. 1
   Disconnect the e23 panel connector.
2. 2
   Disconnect the e19 meter connector.
3. 3
   Measure the resistance of the wire harness side connectors.

Standard resistance

1. 1
   Inspect heater control panel
2. 2
   Remove the heater control panel.
3. 3
   Apply battery voltage and check that the front passenger side seat belt warning light illuminates.

Ok

When the battery's negative (-) lead is applied to terminal 4 and the positive (+) lead is applied to terminal 7, the seat belt warning light does not illuminate.

6. Check clock sub-assembly (power source circuit)

1. 1
   Disconnect the e22 clock connector.
2. 2
   Measure the voltage and resistance of the wire harness side connector.

Standard voltage

Standard resistance

7. Check wire harness (clock - combination meter)

1. 1
   Disconnect the e22 clock connector.
2. 2
   Disconnect the e19 meter connector.
3. 3
   Measure the resistance of the wire harness side connectors.

Standard resistance

8. Inspect clock sub-assembly

1. 1
   Remove the clock.
2. 2
   Apply battery voltage and check that the front passenger side seat belt warning light illuminates.

Ok

When the battery's negative (-) lead is applied to terminal 3 and the positive (+) lead is applied to terminal 5, the seat belt warning light does not illuminate.