Toyota RAV4 Quiz
2Az-fe engine mechanical

Installation

In this manual: 2Az-fe engine mechanical
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
8steps
~48min
2/5difficulty
Done 0 of 8
  1. Install crankshaft position sensor
Notice:

Make sure that the o-ring is not cracked or jammed when installing it.

  1. Apply a light coat of engine oil to the o-ring of the sensor.
Toyota RAV4. Install crankshaft position sensor

  1. Install the sensor with the bolt.
Torque: 9.0 N*m (90 kgf*cm, 80 in.*Lbf)
  1. Install the wire harness clamp.
  2. Install the connector clamp.
  3. Connect the sensor connector.
  4. Confirm that the wire harness of the sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.
  5. Install generator assembly
  6. Install the generator to the vehicle (see page ch- 15).
  7. Connect cable to negative battery terminal
  8. Check for engine oil leakage
    Toyota RAV4. Install generator assembly

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.