2Az-fe engine mechanical

Installation

10steps
~60min
3/5difficulty
Done 0 of 10
  1. Install ecm
  2. Install the 2 brackets to the ecm with the 4 screws.
Torque: 3.0 N*m (30 kgf*cm, 27 in.*Lbf)
Toyota RAV4. Install ecm

  1. Connect the 2 ecm connectors.
Notice:

When connecting the connector, make sure that dirt, water and other foreign matter does not become stuck between the connector and other part.

  1. Connect the 2 ecm connectors and lower the 2 levers.
Notice:

Make sure that the 2 levers are securely lowered.

Toyota RAV4. Installation

  1. Install the ecm with the 3 bolts.
Toyota RAV4. Install ecm

Torque: 6.5 N*m (66 kgf*cm, 57 in.*Lbf)
  1. Install air cleaner case
Toyota RAV4. Install air cleaner case

  1. Install the air cleaner case with the 3 bolts.
Torque: 5.0 N*m (51 kgf*cm, 44 in.*Lbf)
  1. Connect the harness clamp.
  2. Install air cleaner cap (see page es-413)
  3. Connect cable to negative battery terminal
  4. Perform registration
  5. When replacing the ecm, the vehicle identification number (vin) must be input into the replacement ecm (see page es-13).
  6. When replacing the ecm, perform the vehicle stability control system recognition in the ecm (see page cc-12).
  7. Reset memory
  8. When replacing the ecm, perform the reset memory procedure (a/t initialization) (see page ax-18).

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.