Toyota RAV4 Quiz
2Az-fe engine mechanical

Removal

In this manual: 2Az-fe engine mechanical
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
9steps
~54min
2/5difficulty
Done 0 of 9
  1. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove air cleaner cap (see page es-411)
  2. Remove air cleaner case
    Toyota RAV4. Remove air cleaner case

  1. Disconnect the harness clamp.
  2. Remove the 3 bolts and air cleaner case.
  3. Remove ecm
    Toyota RAV4. Remove ecm

  1. Remove the 3 bolts of the ecm with bracket.
  2. Disconnect the 2 ecm connectors.
    Toyota RAV4. Remove ecm

Notice:

After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the connector.

  1. Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ecm connectors.
  2. Remove the ecm with bracket.
    Toyota RAV4. Remove ecm

  1. Remove the 4 screws and 2 ecm brackets.

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.