Toyota RAV4 Quiz
2Az-fe engine mechanical

Removal

In this manual: 2Az-fe engine mechanical
Introduction — 37Interior — 12Exterior — 432Az-fe engine mechanical — 1552Az-fe ignition — 182Az-fe charging — 232Az-fe emission control — 82az-fe exhaust — 32Az-fe fuel — 72Az-fe lubrication — 4Brake — 17Brake control — 63U140f automatic transaxle — 59Instrument panel — 8Suspension — 18Drive shaft — 23Axle — 6Tire and wheel — 30Air conditioning — 93Lighting — 45Cruise control — 21Differential — 12Door lock — 31Engine immobiliser — 21Horn — 5Can communication — 27Mirror — 5Parking brake — 5Power steering — 27Propeller shaft — 3Seat — 29Seat belt — 27Sliding roof — 25Steering column — 6Wiper and washer — 11Supplemental restraint system — 95Other system — 5Maintenance — 14
20steps
~120min
4/5difficulty
Done 0 of 20
  1. Drain engine coolant (see page co-6)
  2. Disconnect cable from negative battery terminal
Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  1. Remove no. 1 Engine cover
  2. Remove the 2 nuts and engine cover.
    Toyota RAV4. Remove no. 1 Engine cover

  1. Remove air cleaner cap
Toyota RAV4. Remove air cleaner cap

  1. Disconnect the mass air flow meter connector.
  2. Disconnect the purge vsv connector.
  3. Disconnect the 4 wire harness clamps.
    Toyota RAV4. Remove air cleaner cap

  1. Disconnect the no. 2 Ventilation hose from the air cleaner hose.
  2. Disconnect the purge line hose from the clamp.
    Toyota RAV4. Remove air cleaner cap

  1. Lock the no. 1 Air cleaner hose clamp, and then disconnect the no. 1 Air cleaner hose from the throttle body.
Toyota RAV4. Remove air cleaner cap

  1. Unfasten the 2 hook clamps, and then remove the air cleaner cap.
  2. Remove the air cleaner filter element from the air cleaner case.
  3. Remove throttle body
    Toyota RAV4. Remove throttle body

  1. Disconnect the purge line hose from the throttle body.
  2. Disconnect the water by-pass hose from the throttle body.
  3. Disconnect the no. 2 Water by-pass hose from the throttle body.
  4. Disconnect the no. 1 Throttle body hose from the throttle body
  5. Disconnect the throttle position sensor and control motor connector.
  6. Disconnect the wire harness clamp.
  7. Disconnect the fuel tube from the clamp.
  8. Remove the 4 bolts, and then remove the fuel pipe support and throttle body.
    Toyota RAV4. Remove throttle body

  1. Remove the gasket from the intake manifold
Toyota RAV4. Remove throttle body

Test yourself

A quick Toyota RAV4 quiz: every answer comes with an explanation and a link to the manual page.