Installation

1. 1
   Install throttle body
2. 2
   Install a new gasket onto the intake manifold.
3. 3
   Install the throttle body and fuel pipe clamp with the 4 bolts.

   

1. 1
   Connect the fuel tube into the clamp.
2. 2
   Connect the wire harness clamp.
3. 3
   Connect the throttle position sensor and control motor connector.
4. 4
   Connect the no. 1 Throttle body hose to the throttle body
5. 5
   Connect the no. 2 Water by-pass hose to the throttle body.
6. 6
   Connect the water by-pass hose to the throttle body.
7. 7
   Connect the purge line hose to the throttle body.

   

2. Install air cleaner cap

1. 1
   Install the air cleaner filter element onto the air cleaner case.
2. 2
   Insert the hinge part of the air cleaner cap into the air cleaner case, then hang the 2 hook clamps.

   

3. Align the matchmarks of the no. 1 Air cleaner hose and throttle body, and then connect the air cleaner hose no. 1 To the throttle body and unfasten the no.

Make sure that the hose clamp is at the correct angle.

1. 1
   Connect the purge line hose to the clamp.
2. 2
   Connect the no. 2 Ventilation hose to the air cleaner hose.

   

1. 1
   Install the 4 wire harness clamps.
2. 2
   Connect the mass air flow meter connector.
3. 3
   Connect cable to negative battery terminal
4. 4
   Add engine coolant (see page co-6)
5. 5
   Check for engine coolant leakage (see page co-1)
6. 6
   Install no. 1 Engine cover

   

1. Install the cover with the 2 nuts.