Removal

1. Disconnect cable from negative battery terminal

1. 1
   Remove no. 1 Engine under cover
2. 2
   Remove front fender apron rh
3. 3
   Remove radiator support opening cover
4. 4
   Drain engine coolant (see page co-6)
5. 5
   Remove front suspension member reinforcement rh (see page em-6)
6. 6
   Remove fan and generator v belt (see page em-6)
7. 7
   Remove generator assembly (see page ch-9)
8. 8
   Remove water pump pulley

   

1. Using sst, remove the 4 bolts and water pump pulley.

10. Remove water pump assembly

1. 1
   Remove the clamp of the crankshaft position sensor from the water pump.
2. 2
   Disconnect the wire of the crankshaft position sensor from the clamp bracket.

   

1. Remove the 4 bolts, 2 nuts and clamp bracket.

4. Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.

Be careful not to damage the contact surfaces of the water pump and cylinder block.