Toyota Sienna Quiz
Brake control

ABS Control System Malfunction

In this manual: Brake control
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

DTC 43 ABS Control System Malfunction

DESCRIPTION

This DTC is output when the VSC system detects a malfunction in the ABS control system.

INSPECTION PROCEDURE

NOTICE: When replacing the brake actuator assembly, perform zero point calibration (See page BC-70).

1 CHECK ABS CONTROL SYSTEM

(a) Clear the DTC (See page BC-82).

(b) Turn the ignition switch to the ON position.

(c) Check if the same DTC is recorded (See page BC-82).

Result

2 RECONFIRM DTC

(a) Turn the ignition switch off.

(b) Clear the DTC (See page BC-82).

(c) Start the engine.

(d) Drive the vehicle at a speed of approximately 40 km/h or more for 60 seconds or more.

(e) Check if the same DTC is recorded (See page BC-82).

Result

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION)

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.