Brake control

ABS Warning Light does not Come ON

~1min read

WIRING DIAGRAM

Refer to ABS Warning Light Remains ON (See page BC-141).

INSPECTION PROCEDURE

1 CHECK ABS WARNING LIGHT

(a) Disconnect the skid control ECU connector.

(b) Turn the ignition switch to the ON position.

(c) Check that the ABS warning light comes on.

OK: ABS warning light comes on.

HINT: If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step (See page BC-79).

REPLACE BRAKE ACTUATOR ASSEMBLY

2 CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)

(a) Turn the ignition switch off.

(b) Disconnect the combination meter connector.

CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance

3 INSPECT COMBINATION METER ASSEMBLY

(a) Check the combination meter (See page ME-4).

HINT: If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step (See page BC-79).

END

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.