Open in Stop Light Switch Circuit

DTC C1249/49 Open in Stop Light Switch Circuit

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

1 CHECK STOP LIGHT SWITCH OPERATION

(a) Check that the stop light comes on when the brake pedal is depressed and goes off when the brake pedal is released.

OK

HINT: Check the stop light bulb as it may have burnt out.

2 INSPECT SKID CONTROL ECU (STP1 TERMINAL)

(a) Disconnect the skid control ECU connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage

3 RECONFIRM DTC

(a) Clear the DTCs (See page BC-82).

(b) Turn the ignition switch to the ON position.

(c) Are the same DTCs detected?

Result

NOTICE: When replacing the brake actuator assembly, perform zero point calibration (See page BC-70).

REPLACE BRAKE ACTUATOR ASSEMBLY

4 INSPECT STOP LIGHT SWITCH

(a) Disconnect the stop light switch assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance

5 CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - SKID CONTROL ECU)

(a) Disconnect the stop light switch connector and skid control ECU connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance

NOTICE: When replacing the brake actuator assembly, perform zero point calibration (See page BC-70).

REPLACE BRAKE ACTUATOR ASSEMBLY