Toyota Sienna Quiz
Lighting

Repair

In this manual: Lighting
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
~1min read

1. INSTALL HEADLIGHT PROTECTOR RETAINER UPPER

INSTALL HEADLIGHT PROTECTOR RETAINER UPPER

HINT:

  • If the installation area of the headlight assembly is damaged, use the supply bracket for low-cost repair.
  • Ensure that the headlight assembly is not damaged.
  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE: After cutting off the part, place the headlight protector retainer upper against the bosses and gradually file away until installation is possible.

INSTALL HEADLIGHT PROTECTOR RETAINER UPPER
  1. Install the headlight protector retainer upper with the 2 screws.

2. INSTALL LOWER HEADLIGHT BRACKET

HINT:

  • If the installation area of the headlight assembly is damaged, use the supply bracket for low-cost repair.
  • Ensure that the headlight assembly is not damaged.
INSTALL LOWER HEADLIGHT BRACKET
  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE: After cutting off the part, place the lower headlight bracket against the bosses and gradually file away until installation is possible.

INSTALL LOWER HEADLIGHT BRACKET
  1. Install the lower headlight bracket with the 2 screws.

3. INSTALL INNER HEADLIGHT MOUNTING BRACKET

HINT:

  • If the installation area of the headlight assembly is damaged, use the supply bracket for low-cost repair.
  • Ensure that the headlight assembly is not damaged.
INSTALL INNER HEADLIGHT MOUNTING BRACKET
  1. Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE: After cutting off the part, place the inner headlight mounting bracket against the bosses and gradually file away until installation is possible.

INSTALL INNER HEADLIGHT MOUNTING BRACKET
  1. Install the inner headlight mounting bracket with the 2 screws.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.