Installation

1. INSTALL VANE PUMP ASSEMBLY

(a) Install the vane pump assembly with the 2 bolts.

Torque:

21 N·m {214 kgf·cm, 15 ft·lbf}

(b) Connect the ground wire with the bolt.

Torque:

8,5 N·m {87 kgf·cm, 75 in·lbf}

2. CONNECT PRESSURE FEED TUBE ASSEMBLY

(a) Install a new gasket to the pressure feed tube assembly.

(b) Connect the pressure feed tube assembly with the union bolt.

Torque:

50 N·m {510 kgf·cm, 37 ft·lbf}

(c) Connect the oil pressure switch connector.

NOTICE:

Make sure that no oil adheres to the connector.

3. CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

(a) Connect the No. 1 oil reservoir to pump hose and slide the clip to secure it.

4. INSTALL FRONT FENDER APRON UPPER SEAL RH

5. INSTALL FAN AND GENERATOR V BELT

6. ADD POWER STEERING FLUID

7. BLEED POWER STEERING FLUID

8. INSPECT FOR POWER STEERING FLUID LEAK

9. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}

10. INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}