The ECM sends signals such as A/T information signals, dynamic radar cruise control operation signals, brake operation demand signals, and buzzer operation demand signals to the skid control ECU (brake actuator assembly) when the dynamic radar cruise control is operating. Therefore, if the skid control ECU (brake actuator assembly) detects a communication error with the ECM, it sends a malfunction signal back to the ECM.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
P1631
Communication Error from ECM to VSC
While the vehicle speed is 36 km/h or more and the dynamic radar cruise control system is operating, the ECM continuously receives a logical error signal from the skid control ECU (brake actuator assembly) for approximately 1 second or more.
CAN communication circuit
ECM
Skid control ECU (brake actuator assembly)
NOTICE:
Before replacing the ECM, refer to Registration.
Click here
First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.
Click here
PROCEDURE
CHECK CAN COMMUNICATION SYSTEM
(a) Using the Techstream, check if the CAN communication system is functioning normally.
Click here
Result
Proceed to
CAN communication system DTCs are not output
OK
CAN communication system DTCs are output
NG
NG
GO TO CAN COMMUNICATION SYSTEM
OK
CHECK FOR DTCs (RADAR CRUISE1)
(a) Clear the DTCs.
Click here
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
Turn the ignition switch to ON.
Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
Drive the vehicle at 36 km/h or more for 1 second or more.
(c) Check for DTCs.
Click here
Result
Proceed to
DTC P1631 is not output
A
DTC P1631 is output
B
A
USE SIMULATION METHOD TO CHECK
B
REPLACE ECM
(a) Replace the ECM.
for 1UR-FE: Click here
for 3UR-FE: Click here
for 3UR-FBE: Click here
NEXT
CHECK FOR DTCs (RADAR CRUISE1)
(a) Clear the DTCs.
Click here
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
Turn the ignition switch to ON.
Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
Drive the vehicle at 36 km/h or more for 1 second or more.
(c) Check for DTCs.
Click here
Result
Proceed to
DTC P1631 is not output
A
DTC P1631 is output
B
A
END
B
REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)