This DTC is stored when there is a malfunction in the ECM.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
P0575
Cruise Control Input Circuit
Either of the following conditions is met:
When the ignition switch is ON, STP signals received by the ECM supervisory CPU and that received by the control ECU do not match for approximately 0.2 seconds or more.
While the dynamic radar cruise control system is operating, the dynamic radar cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed after cruise cancel signal (STP signal) is received by the ECM.
ECM
DTC Detection Conditions:
Vehicle Condition
Pattern 1
Pattern 2
Diagnosis Condition
Ignition switch to ON
○
-
Dynamic radar cruise control system is operating
-
○
Malfunction Status
STP signals received by the ECM supervisory CPU and that received by the control ECU do not match
○
-
The dynamic radar cruise control system control of vehicle speed is not canceled and approximately 0.4 seconds have elapsed after cruise cancel signal (STP signal) is received by the ECM.
-
○
Detection Time
0.2 seconds or more
0.4 seconds or more
Number of Trips
1 trip
1 trip
NOTICE:
Before replacing the ECM, refer to Registration.
Click here
HINT:
The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the ignition switch off.
PROCEDURE
CHECK FOR DTCs (RADAR CRUISE1)
(a) Clear the DTCs.
Click here
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which dynamic radar cruise control operation is possible.
Turn the cruise control system on using the cruise control main switch (ON-OFF button).