The skid control ECU (brake actuator assembly) sends signals such as cruise control cancel signals and brake demand response signals to the ECM when the dynamic radar cruise control system is operating.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
P1630
Communication Error from VSC to ECM
While the vehicle speed is 36 km/h or more and the dynamic radar cruise control system is operating, communication data from the skid control ECU (brake actuator assembly) is logically inconsistent for approximately 0.5 seconds or more.
CAN communication circuit
Skid control ECU (brake actuator assembly)
ECM
NOTICE:
Before replacing the ECM, refer to Registration.
Click here
First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.
Click here
PROCEDURE
CHECK CAN COMMUNICATION SYSTEM
(a) Using the Techstream, check if the CAN communication system is functioning normally.
Click here
Result
Proceed to
CAN communication system DTCs are not output
OK
CAN communication system DTCs are output
NG
NG
GO TO CAN COMMUNICATION SYSTEM
OK
CHECK FOR DTCs (RADAR CRUISE1)
(a) Clear the DTCs.
Click here
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
Turn the ignition switch to ON.
Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
Drive the vehicle at 36 km/h or more for 0.5 seconds or more.
(c) Check for DTCs.
Click here
Result
Proceed to
DTC P1630 is not output
A
DTC P1630 is output
B
A
USE SIMULATION METHOD TO CHECK
B
REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY)
(a) Replace the skid control ECU (brake actuator assembly).
Click here
NEXT
CHECK FOR DTCs (RADAR CRUISE1)
(a) Clear the DTCs.
Click here
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
Turn the ignition switch to ON.
Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
Drive the vehicle at 36 km/h or more for 0.5 seconds or more.