Vehicle Interior
Driver Side Power Window does not Operate with Power Window Master Switch
DESCRIPTION
- If the driver side manual UP/DOWN function does not operate, there may be a malfunction in master switch, driver side motor or harness and connector.
WIRING DIAGRAM
PROCEDURE
INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
(a) Remove the front power window regulator motor assembly LH (See page ).
(b) Inspect the front power window regulator motor assembly LH (See page ).
| NG |
 |
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (MASTER SWITCH - DRIVER SIDE MOTOR)
(a) Disconnect the N2 master switch connector.
(b) Disconnect the N3 motor connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
N2-3 (U) - N3-2 |
Always |
Below 1 Ω |
N2-4 (D) - N3-1 |
Always |
Below 1 Ω |
N2-3 (U) or N3-2 - Body ground |
Always |
10 kΩ or higher |
N2-4 (D) or N3-1 - Body ground |
Always |
10 kΩ or higher |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
(a) Remove the power window regulator master switch assembly (See page ).
(b) Inspect the power window regulator master switch assembly (See page ).
| OK |
 |
GO TO POWER WINDOWS DO NOT OPERATE AT ALL |
| NG |
 |
REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |
|
Was this page helpful?