Key-off Operation Function Operates even if Operating Conditions are not Satisfied
In this manual: Vehicle Interior
~2min read
DESCRIPTION
When the front doors are closed and the ignition switch is turned from ON to OFF, each power window regulator motor can control its power window operation for approximately 43 +/-1.5 seconds by receiving operation permission signals from the main body ECU (multiplex network body ECU). However, when approximately 43 +/-1.5 seconds have elapsed, or the driver side door or front passenger side door is opened within approximately 43 +/-1.5 seconds after turning the ignition switch off, the power window regulator motor stops operating.
During the AUTO DOWN function operation, when 43 +/-1.5 seconds have passed and the key-off operation is prohibited, the window operation stops immediately.
The front passenger side power window and rear power windows cannot be operated when the window lock switch is pressed.
WIRING DIAGRAM
PROCEDURE
CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH OFF
(a) Check the power window operation function after the ignition switch is turned OFF.
Result:
Result
Proceed to
Front side door is opened within 43 +/-1.5 seconds but power window can still operate
A
43 +/-1.5 seconds pass and power windows can still operate
B
B
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
A
READ VALUE USING TECHSTREAM (DOOR COURTESY SWITCH)
(a) Use the Data List to check if the main body ECU (multiplex network body ECU) is functioning properly.
Main Body:
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
D Door Courtesy SW
Driver side door courtesy switch signal / ON or OFF
ON: Driver door open
OFF: Driver door closed
-
P Door Courtesy SW
Front passenger side door courtesy switch signal / ON or OFF
ON: Front passenger door open
OFF: Front passenger door closed
-
OK:
Tester display changes normally when door courtesy switch is operated.
OK
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)