Vehicle Interior
Inspection
INSPECTION
PROCEDURE
1. INSPECT HEADLIGHT ASSEMBLY LH
(a) Apply battery voltage to the connector and check the light illumination condition.
OK:
Battery Connection | Specified Condition |
| If the result is not as specified, replace the headlight assembly LH. |
Positive (+) → 6
Negative (-) → 4 |
Parking light illuminates |
Positive (+) → 5
Negative (-) → 4 |
Daytime running light illuminates |
Positive (+) → 2
Negative (-) → 4 |
Low beam illuminates |
Positive (+) → 1
Negative (-) → 4 |
High beam illuminates |
|
 |
*a |
Component without harness connected
(Headlight Assembly LH) |
|
|
2. INSPECT HEADLIGHT ASSEMBLY RH
(a) Apply battery voltage to the connector and check the light illumination condition.
OK:
Battery Connection | Specified Condition |
| If the result is not as specified, replace the headlight assembly RH. |
Positive (+) → 6
Negative (-) → 4 |
Parking light illuminates |
Positive (+) → 5
Negative (-) → 4 |
Daytime running light illuminates |
Positive (+) → 2
Negative (-) → 4 |
Low beam illuminates |
Positive (+) → 1
Negative (-) → 4 |
High beam illuminates |
|
 |
*a |
Component without harness connected
(Headlight Assembly RH) |
|
|
|
Was this page helpful?