Engine, Hybrid System
Power Source Circuit
DESCRIPTION
This circuit provides power to operate the forward recognition camera.
WIRING DIAGRAM
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (POWER SOURCE VOLTAGE)
(a) Disconnect the forward recognition camera connector. |
 |
*a |
Front view of wire harness connector
(to Forward Recognition Camera) |
|
|
(b) Turn the ignition switch to ON.
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
W9-7 (IGB) - Body ground |
Ignition switch ON |
11 to 14 V |
(d) Connect the forward recognition camera connector.
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (FORWARD RECOGNITION CAMERA - BODY GROUND)
(a) Disconnect the forward recognition camera connector. |
 |
*a |
Front view of wire harness connector
(to Forward Recognition Camera) |
|
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition | Specified Condition |
W9-10 (GND) - Body ground |
Always |
Below 1 Ω |
(c) Connect the forward recognition camera connector.
| OK |
 |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
Was this page helpful?