DESCRIPTION
The forward recognition camera receives vehicle speed tolerance signals from the combination meter assembly. If the combination meter assembly detects a vehicle speed tolerance malfunction signal, it informs the forward recognition camera via CAN communication, and DTC C1AA2 is stored.
DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
C1AA2 |
Vehicle Speed Tolerance Malfunction |
When the vehicle is being driven at a speed of 5 km/h or more 3 seconds after the ignition switch is turned to ON, a signal from the combination meter assembly indicating an abnormal vehicle speed tolerance is detected by the forward recognition camera for 50 seconds or more. |
- Meter/gauge system
- Combination meter assembly
- Forward recognition camera
|
NOTICE:
- When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.
- If the forward recognition camera has been replaced with a new one, be sure to perform forward recognition camera learning.
Click here 
- First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.
Click here 
- When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
PROCEDURE
INSPECT COMBINATION METER ASSEMBLY (OPERATION CHECK)
(a) Perform Operation Check of the meter/gauge system.
Click here 
HINT:
Check the meter function by referring to Operation Check for the combination meter assembly.
Result | Proceed to |
Combination meter assembly is normal |
A |
Combination meter assembly is malfunctioning |
B |
| B |
 |
CHECK METER / GAUGE SYSTEM (SPEEDOMETER MALFUNCTION) |
| A |
 |
|
CHECK DTC OUTPUT
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / LKA/LDA / Trouble Codes.
(e) Clear the DTCs.
(f) Make sure that the DTC detection conditions are met.
HINT:
If the following procedure is not performed, the previously output DTC cannot be detected.
(g) Check for DTCs.
Result | Proceed to |
DTC C1AA2 is output |
A |
DTC C1AA2 is not output |
B |
| B |
 |
USE SIMULATION METHOD TO CHECK |
| A |
 |
|
REPLACE FORWARD RECOGNITION CAMERA
(a) Replace the forward recognition camera.
Click here 
(b) Adjust the forward recognition camera.
Click here 
| NEXT |
 |
|
CHECK DTC OUTPUT
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / LKA/LDA / Trouble Codes.
(e) Clear the DTCs.
(f) Make sure that the DTC detection conditions are met.
HINT:
If the following procedure is not performed, the previously output DTC cannot be detected.
(g) Check for DTCs.
Result | Proceed to |
DTC C1AA2 is output |
A |
DTC C1AA2 is not output |
B |
| A |
 |
REPLACE COMBINATION METER ASSEMBLY |
| B |
 |
END (FORWARD RECOGNITION CAMERA WAS DEFECTIVE) |
|