DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
Do not apply excessive force to the W9 forward recognition camera connector.
(a) Check forward recognition camera
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
W9-7 (IGB) - Body ground
R - Body ground
Power source
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V
W9-10 (GND) - Body ground
W-B - Body ground
Ground
Always
Below 1 Ω
W9-5 (CA1P) - Body ground
BE - Body ground
CAN communication signal
Ignition switch ON
Pulse generation
(Waveform 1)
W9-11 (CA1N) - Body ground
W - Body ground
Pulse generation
(Waveform 2)
W9-6 (CANH) - Body ground
G - Body ground
Pulse generation
(Waveform 1)
W9-12 (CANL) - Body ground
W - Body ground
Pulse generation
(Waveform 2)
(b) WAVEFORM 1
(1) CAN communication signal
Item
Content
Terminal Name
Between W9-5 (CA1P) and W9-10 (GND)
Between W9-6 (CANH) and W9-10 (GND)
Tester Range
1 V/DIV., 10 μsec./DIV.
Condition
Ignition switch ON
HINT:
The waveform varies depending on the CAN communication signal.
(c) WAVEFORM 2
(1) CAN communication signal
Item
Content
Terminal Name
Between W9-11 (CA1N) and W9-10 (GND)
Between W9-12 (CANL) and W9-10 (GND)
Tester Range
1 V/DIV., 10 μsec./DIV.
Condition
Ignition switch ON
HINT:
The waveform varies depending on the CAN communication signal.