Installation

1. INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY

(a) Insert the front end of the front door outside handle assembly into the front door outside handle frame.

(b) Insert the rear end of the front door outside handle assembly into the front door outside handle frame, then slide the front door outside handle assembly toward the front of the vehicle to install it.

(c) Move the lever back in the direction indicated by the arrow in the illustration to lock the door outside handle assembly.

(d) Connect the connector.

(e) Engage the 2 claws.

2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER (for Front Passenger Side)

3. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

5. INSTALL FRONT DOOR SERVICE HOLE COVER

6. INSTALL DOOR SIDE AIRBAG SENSOR

7. INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY

8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

9. INSTALL COURTESY LIGHT ASSEMBLY

10. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

11. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

12. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

14. INITIALIZE POWER WINDOW CONTROL SYSTEM

(See page )

15. INSPECT SRS WARNING LIGHT

(See page )