Removal

HINT:

• Use the same procedure for the LH side and RH side.
• The following procedure is for the LH side.
• If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE FRONT WHEEL

3. REMOVE FRONT FENDER OUTSIDE MOULDING LH

4. REMOVE FRONT FENDER LINER LH

5. REMOVE FRONT SPEED SENSOR

(a) Disconnect the front speed sensor connector and remove the 2 clamps.

(b) Remove the bolt and No. 2 sensor clamp from the body. Text in Illustration *1 No. 2 Sensor Clamp

(c) Remove the bolt, No. 1 sensor clamp and flexible hose together from the shock absorber assembly. Text in Illustration *1 No. 1 Sensor Clamp

(d) Remove the bolt, resin clamp and front speed sensor. NOTICE: Prevent foreign matter from attaching to the front speed sensor tip. Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed. Text in Illustration *1 Resin Clamp