Sleep Operation Failure of Occupant Classification ECU (B1796)

In sleep mode, the occupant classification ECU reads the condition of each sensor while the ignition switch is off.

In this mode, if occupant classification ECU detects an internal malfunction, DTC B1796 is output.

HINT:

When DTC B1650/32 is detected as a result of troubleshooting for the airbag system, check the DTCs stored in the occupant classification ECU. When DTC B1796 is output, perform troubleshooting for the DTC.

1. REPLACE OCCUPANT CLASSIFICATION ECU

(a) Turn the ignition switch off.

(b) Disconnect the cable from the negative (-) battery terminal.

(c) Replace the occupant classification ECU (See page ).

NEXT

1. PERFORM ZERO POINT CALIBRATION

(a) Connect the cable to the negative (-) battery terminal.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Using the Techstream, perform Zero Point Calibration (See page ).

OK:

"Zero Point Calibration is complete." is displayed.

NEXT

1. PERFORM SENSITIVITY CHECK

(a) Using the Techstream, perform Sensitivity Check (See page ).

Standard:

27 to 33 kg (59.5 to 72.8 lb)

NEXT

END