Assembly overview - control unit and hydraulic unit, LHD vehicles

1 -	Brake line

From primary piston circuit of brake master cylinder to hydraulic unit.

Identification: Ш 6 mm and flare nut with thread M 12 x 1

14 N·m

2 -	Brake line

From secondary piston circuit of brake master cylinder to hydraulic unit.

Identification: Ш 6 mm and flare nut with thread M 12 x 1

14 N·m

3 -	Brake servo

Assembly overview → Chapter.

Checking brake servo → Vehicle diagnostic tester

Removing and installing → Chapter

4 -	ABS control unit -J104- and ABS hydraulic unit -N55-

Removing and installing → Chapter

5 -	Brake line

To rear right brake caliper

Identification: Ш 5.25 mm and flare nut with thread M 10 x 1

14 N·m

6 -	Brake line

To front left brake caliper.

Identification: Ш 5.25 mm and flare nut with thread M 10 x 1

14 N·m

7 -	Brake line

To front right brake caliper

Identification: Ш 5.25 mm and flare nut with thread M 10 x 1

14 N·m

8 -	Brake line

To rear left brake caliper

Identification: Ш 5.25 mm and flare nut with thread M 10 x 1

14 N·m

9 -	Brake line

To primary piston circuit of brake master cylinder

Identification: Ш 6 mm and flare nut with thread M 12 x 1

14 N·m

10 -	Brake line

To secondary piston circuit of brake master cylinder

Identification: Ш 6 mm and flare nut with thread M 12 x 1

14 N·m

11 -

Bracket

12 -

Bolt

8 N·m

13 -	Rubber damper

Ensure that rubber dampers of retainer are not pressed out of bracket when installing. After installation, check that the ABS hydraulic unit -N55- is firmly seated, or malfunction can occur.

14 -

Bracket

15 -

Nut

20 N·m

16 -	Brake system pressure accumulator -VX70-

Location → Chapter

Assembly overview → Chapter.

Removing and installing → Chapter

17 -	Brake line

To brake servo.

Identification: Ш 5.25 mm and flare nut with thread M 10 x 1

14 N·m

18 -	Brake line

To brake system pressure accumulator -VX70-

Identification: Ш 5.25 mm and flare nut with thread M 10 x 1

14 N·m