Assembly overview - drive shaft, triple roller joint AAR3300i

1 -

Bolt

Renew after removing

Loosening and tightening → Chapter

Before fitting, clean the threads in the CV joint using a thread tap.

200 N·m +180°

2 -	Outer constant velocity joint

Renew only as complete unit

Removing → Anchor.

Installing: drive onto shaft with plastic hammer until compressed circlip seats

Checking → Chapter

3 -	Retaining ring

Renew after removing

Insert in groove in shaft

4 -

Clamp

Renew after removing

Tightening → Fig.

5 -	Boot for constant velocity joint

Check for splits and chafing

Material: Hytrel (polyester elastomer)

6 -

Clamp

Renew after removing

Tightening → Fig.

7 -	Drive shaft

8 -	Triple roller star with rollers

The chamfer -arrow- points towards drive shaft splines.

Removing → Anchor.

9 -	Retaining ring

Renew after removing

Insert in groove in shaft

10 -

Clamp

Renew after removing

Tightening → Fig.

11 -	Boot for triple roller joint

Check for splits and chafing

12 -

Clamp

Renew after removing

Tightening → Fig.

13 -

Adapter

14 -	Joint body

Removing → Anchor.

15 -	Multi-point socket head bolt

M10 x 23

Initially tighten diagonally to 10 N·m and then tighten diagonally to specified torque.

70 N·m

16 -	Joint body

Removing → Anchor.

17 -	Retaining ring

Renew after removing

Insert in groove in shaft