Volkswagen Golf Quiz
Electrical system

Contact corrosion

In this manual: Electrical system
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read

Contact corrosion can occur if unsuitable fasteners (bolts, nuts, washers, etc.) are used. Therefore, only fastening elements with a special surface coating are installed in the vehicle. In addition, rubber and plastic parts as well as adhesives are made of electrically non-conductive materials. If there is any doubt about the suitability of parts, a general rule is to use new parts → Electronic Parts Catalogue.

Please observe the following:

Use only Genuine replacement parts which are tested and compatible with aluminium.

Use only Volkswagen Genuine Accessories.

Damage due to contact corrosion is not covered by warranty.

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.