Communication
Antenna Systems
In this manual: Communication
5steps
~30min
2/5difficulty
Done 0 of 5
General Information
The antenna system for radios without diversity function consists of one roof antenna.
Note
- In case of complaints, it is essential to know the function and operation of the radio systems.
- Additional information → Owner's Manuals.
- When reconnecting the battery, remember to check the vehicle equipment (radio, clock, comfort electronics, etc.) according to the repair manual and/or owner's manual.
For repair work or fault finding, use the vehicle diagnostic tester in the "Guided Fault Finding" or "Guided Functions" function.
Installation Locations Overview - Antenna Systems
Antenna system "RCD 215" and portable navigation and infotainment system -J982-

- Radio -R-
- "Structure of Radio / Radio Navigation Systems"
- Antenna cable
- Antenna -R11-
- "Removing and Installing Roof Antenna"
- Splitter
- portable navigation and infotainment system -J982-
- "Structure of Radio / Radio Navigation Systems"
Removing and Installing Roof Antenna
Removing:
- Lower the headliner → Trim Panels/Insulation.
- Remove C-pillar trim, left and right → Trim Panels/Insulation.
- Release B-pillar trim, left and right → Trim Panels/Insulation.
- Carefully lower headliner.
- Disconnect antenna cable connector.
- Unscrew retaining nut -1- of roof antenna.
- Remove roof antenna upwards.
Installing:
Installation is carried out in the reverse order of removal.
Note
- When inserting the antenna, make sure the seal is seated correctly. The two guide lugs of the seal must engage the holes -arrows- in the antenna base.

- After inserting the antenna, make sure the antenna cables -2- are routed correctly through the cable passage -arrow- in retaining nut -1-.

Repairing Antenna Cables
→ Electrical System General Information.
Was this page helpful?