Electrical system

Immobilizer

~1min read

Removing and installing immobilizer control module

General description:

The up! is equipped with the fourth-generation immobilizer with online connection and download. An essential component of the fourth-generation immobilizer is a central database in which all theft-relevant data of the participating control modules is stored. It is not possible to adapt the control modules involved in the immobilizer without an online connection to this database.

Online system test.

  • There is no PIN query of the immobilizer components by fax and no temporary release of the components.
  • All components involved in the immobilizer must be taught in online.
  • All ignition keys, including reordered keys, are pre-coded to a specific vehicle at the factory and can only be taught to that vehicle.
  • When reordering ignition keys, the respective vehicle identification number must be provided.
  • Adapting components from other group brands in Volkswagen vehicles is no longer possible.

Immobilizer components:

  • Immobilizer control module -J362-
  • Engine control module -J623-
  • Immobilizer reader coil -D2-
  • Ignition key

Note

After replacing the lock set or control modules, the function "New identity when changing all components" must be run.

Functions of the immobilizer control module -J362-:

  • Communication of all components involved in the immobilizer with each other.
  • Encryption of data between the participating control modules.

The immobilizer control module -J362- is integrated into the instrument cluster. If the control module is defective, the entire instrument cluster must be replaced.

- Remove and install instrument cluster.

Removing and installing immobilizer reader coil

The immobilizer reader coil -D2- is connected to the ignition lock cylinder and cannot be replaced separately.

- Remove and install lock cylinder.