Radiatore

INFORMAZIONI GENERALI

Radiator mounting on the vehicle.

3. BULLONE.

5. RADIATORE.

6. FAN SHROUD

Rimuovere o scollegare.

PROCEDURA.

1. Cavo negativo della batteria..

2. Lower hose 15 from the radiator neck..

3. Drain the coolant from the cooling system..

4. Loosen the clamp and remove upper hose 18 from the radiator neck..

5. Loosen the clamp and remove the overflow tube

38..

6. Electrical connector of the oxygen sensor on the fan shroud (see Fig. Electrical connectors on the fan shroud).

Fig. Electrical connectors on the fan shroud).

7. Electrical connector of the fan (see Fig. Electrical connectors on the fan shroud). On vehicles equipped with an automatic transmission,.

disconnect the transmission fluid cooler hoses from the cooler in the left.

radiator tank in the following sequence..

8. Remove the two radiator mounting bolts (see Fig. Radiator mounting on the.

vehicle)..

9. Remove the radiator assembly with the fan..

10. Remove the two bolts and remove the fan assembly from the radiator..

Installazione o collegamento.

PROCEDURA.

1. Install the fan assembly to the radiator, install two bolts. Tighten the fan-to-radiator bolts to a torque of 10 N·m..

2. Install the radiator assembly with the fan on the vehicle. Install two bolts. Tighten the radiator mounting bolts to a torque of 15 N·m. On vehicles equipped with an automatic transmission,.

connect the transmission fluid cooler hoses to the cooler in the left radiator tank in the following sequence. 2a. Connect the upper hose to the left radiator tank. Tighten the fitting..

Tighten the transmission fluid cooler hose fitting.

torques of 22 N·m..

2b. Raise and properly support the vehicle..

2c. Connect the lower hose to the left radiator tank. Tighten the fitting..

Tighten the transmission fluid cooler hose fitting.

alla coppia 22 N·m..

2d. Lower the vehicle..

3. Connettore elettrico della ventola..

4. Electrical connector of the oxygen sensor on the fan shroud.

5. Install the overflow tube 38, secure the clamp..

6. Install the lower and upper hoses on the radiator necks, secure the clamps. Fill the cooling system with coolant..

7. Negative battery cable. Tighten the negative battery cable clamp to a torque of 15 N·m.