Daewoo Nexia Quiz
Cooling System

Radiator

In this manual: Cooling System
OWNER'S MANUAL — 12Vehicle Maintenance — 15Maintenance — 16Engine (Single Overhead Camshaft) — 50Engine (dual overhead camshafts) — 45Cooling System — 14Fuel and Exhaust Systems — 31Engine Electrical Equipment — 16Ignition System — 8Electronic Control Unit and Sensors — 12Clutch — 11Five-Speed Transmission and Final Drive RPO MM5 — 16Automatic Transmission — 46Wheels and Tires — 17Front Suspension — 13Front Axle Drive Shafts — 10Rear Suspension — 12Brake System — 54Body — 127Heating, Ventilation and Air Conditioning System — 21Electrical System — 7Wiring Diagrams — 25
~2min read
01020304050107N·mlb·ft
Tightening torque found on this page

GENERAL INFORMATION

Крепление радиатора на автомобил.
Radiator mounting on the vehicle.

3. BOLT.

5. RADIATOR.

6. FAN SHROUD

Remove or disconnect:

PROCEDURE.

1. Disconnect the negative battery cable.

2. Disconnect the lower hose 15 from the radiator outlet.

3. Drain the coolant from the cooling system.

4. Loosen the clamp and disconnect the upper hose 18 from the radiator neck.

5. Loosen the clamp and remove the breather pipe.

38..

6. Disconnect the oxygen sensor electrical connector on the fan shroud (see

Fig. Electrical Connectors on the Fan Shroud).

7. Disconnect the electrical connector of the fan (see Fig. Electrical Connectors on the Fan Shroud). On vehicles equipped with an automatic transmission,

disconnect the transmission fluid cooler hoses from the left

radiator tank in the following sequence.

8. Remove the two radiator mounting bolts (see Fig. Radiator Mounting on the

vehicle).

9. Remove the radiator assembly with the fan.

10. Remove the two bolts and remove the fan assembly from the radiator.

Installation

PROCEDURE.

1. Install the fan assembly to the radiator and install the two bolts. Tighten the fan-to-radiator bolts to 10 N·m.

2. Install the radiator assembly with the fan to the vehicle. Install the two bolts. Tighten the radiator mounting bolts to 15 N·m. On vehicles equipped with

an automatic transmission, connect the transmission fluid cooler hoses to the left radiator tank in the following sequence. 2a. Connect the upper hose to the left radiator tank. Tighten the fitting.

Tighten the transmission fluid cooler hose fitting to

torque 22 N·m.

2b. Raise and securely support the vehicle.

2c. Connect the lower hose to the left radiator tank. Tighten the fitting.

Tighten the transmission fluid cooler hose fitting to

to 22 N·m..

2d. Lower the vehicle.

3. Fan electrical connector..

4. Connect the electrical connector of the oxygen sensor on the fan shroud.

5. Install the breather pipe 38 and secure the clamp.

6. Connect the lower and upper hoses to the radiator necks and secure the clamps. Fill the cooling system with coolant.

7. Negative battery cable. Tighten the negative cable clamp to 15 N·m.

Test yourself

A quick Daewoo Nexia quiz: every answer comes with an explanation and a link to the manual page.