Audio system
After-sales operations: audio system
In this manual: Audio system
~2min read
READING FAULTS
The following faults can be read using the diagnostic tool:
- no communication with the multifunction screen,
- car radio malfunction,
- antenna input fault.
READING PARAMETERS
The following parameters can be read using the diagnostic tool:
| PARAMETER | PARAMETER STATUS | PARAMETER DEFINITION |
| Vehicle identification number | VIN code | Reads the vehicle's VIN code |
| Car radio identification by VIN code | Not stored Stored |
Checks whether the VIN code is stored in the car radio |
| Geographic area of use | Western Europe. Japan. Latin America. Asia. India. Eastern Europe. ARABIA |
Checks whether the car radio is configured for the correct geographic area |
| BSI multiplexed | Absent. Present |
Checks whether the car radio is part of the multiplexed network |
| Fader and rear speakers | Inactive. Active |
Checks whether the car radio is configured for 2 or 4 audio outputs. |
| AM band | Inactive. Active |
Checks whether the radio is configured for an electric vehicle |
| Speed-sensitive volume | Inactive. Active |
Checks whether the radio volume is linked to vehicle speed |
| Audio output configuration | Speaker output. Line out output |
Checks the radio output signal format (with or without amplifier) |
| Volume level correction law | Law No. 0 … Law No. 15 |
Checks the speed-sensitive volume table in use |
| Illumination table | 0x00 … 0 xFF |
Checks the illumination level of the radio buttons |
| Signal quality | 0 15 |
Checks the signal quality using an index from 0 to 15 |
| Signal level | 0 15 |
Checks the signal reception level using an index from 0 to 15 |
ACTUATOR TEST
The following tests can be performed using the diagnostic tool:
- upward frequency scan,
- repeated audio signal output on the front left audio output,
- repeated audio signal output on the front right audio output,
- repeated audio signal output on the rear left audio output,
- repeated audio signal output on the rear right audio output,
- illumination of the radio front panel.
CODING
The following parameters can be coded using the diagnostic tool:
- VIN code configuration,
- tuner geographic area configuration,
- activation of speed-sensitive volume,
- audio output format configuration,
- active output count configuration,
- AM band activation / deactivation,
- presence of a BSI and a VAN Comfort network,
- volume level correction law,
- front panel illumination table.
OPERATIONS TO PERFORM
The following operations are to be performed using the diagnostic tool:

Test yourself
A quick Citroen C5 Aircross quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?