Hub

Remove or disconnect

Removing seal A. SCREWDRIVER.

10. SEAL.

12. HUB

PROCEDURE.

1. Raise the vehicle and secure it properly.

2. Wheels.

3. Brake drums (locking screw; if necessary, loosen the parking brake cable.

Parking brake cable, if necessary. Using a screwdriver, move the expander lever inward.

parking brake cable).

Warning.

Do not strike the brake drum with a hammer, as this may damage the.

bearings.

4. Dust cap 17, cotter pin 15 and nut

16..

5. Hub 12 with lock washer

14..

6. Seal 10 from hub 12 using a screwdriver.

7. Cage with rollers and inner race of tapered bearing 11 from the hub.

12..

8. Outer race of bearing 11 from hub 12 using a puller or a suitable drift.

suitable drift.

9. Outer race of bearing 13 from hub 12 using a puller or a suitable drift.

suitable drift.

10. Clean the spindle and inspect it for condition and damage.

Install or connect

Installing inner bearing seal

12. HUB

PROCEDURE.

1. Press the outer race of bearing 13 into hub 12 until it seats, using installation tool KM-266A.

2. Press the outer race of bearing 11 into hub 12 until it seats, using installation tool KM-266A.

3. Inner bearing

11..

4. Lubricate or fill all cavities with bearing grease.

bearings 11 and 13, the seal lip 10 and the hub.

12..

5. Press the seal into the hub.

12..

6. Install hub 12 and lock washer 14 onto the spindle.

7. Nut.

8. Brake drum.

8a. Tighten the brake drum locking screw.

8b. Install the rear wheels and tighten the bolts to 90 N·m.

9. Adjust the wheel bearings.

10. Adjust the parking brake.

11. Lower the vehicle.