Ford Focus Quiz
Powertrain

Fuel Vapor Tube Assembly

In this manual: Powertrain
Vehicle - General — 4Accessories — 40Body — 237Chassis — 113Electrical — 19HVAC — 44Powertrain — 292
10steps
~60min
3/5difficulty
01020304050118N·mlb·ft
Tightening torque found on this page
Done 0 of 10

Item Part Number Description
1 9034 Fuel tank filler pipe
2 W709393 Fuel tank filler pipe bracket bolt
3 — Fuel tank filler pipe bracket bolt (part of 9034)
4 — Fuel tank filler pipe recirculation tube (part of 9034)
5 9E857 Evaporative Emission (EVAP) canister
6 — Fuel vapor tube assembly-to-fuel tank filler pipe recirculation tube quick connect coupling (part of 9K164)
7 9K164 Fuel vapor tube assembly
8 — Fuel Tank Pressure (FTP) sensor (part of 9K164)
9 14A464 FTP sensor electrical connector
10 — Fuel vapor tube assembly-to-EVAP canister quick connect coupling (part of (9K164)
11 — Fuel vapor tube assembly-to-fuel tank quick connect coupling (part of 9K164)
12 9002 Fuel tank

Removal and Installation WARNING: Do not
smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury. WARNING: Do not
carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury. WARNING: Always
disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02.
  2. Disconnect the battery ground cable. For additional information, refer to Section 414-01.
  3. Disconnect the Fuel Tank Pressure (FTP) sensor electrical connector.
  4. Remove the RH rear wheel and tire. For additional information, refer to Section 204-04.
  5. Remove the retainers and the RH rear splash shield.
  1. Remove the 2 bolts from the fuel tank filler pipe brackets.
    • To install, tighten to 11 N·m.
  2. Disconnect the fuel vapor tube assembly-to-fuel tank filler pipe recirculation tube quick connect coupling. For additional information, refer to Section 310-00.
  3. Disconnect the fuel vapor tube assembly-to-Evaporative Emission (EVAP) canister quick connect coupling. For additional information, refer to Section 310-00.
  4. Disconnect the fuel vapor tube assembly-to-fuel tank quick connect coupling. For additional information, refer to Section 310-00.
    • Remove the fuel vapor tube assembly.
  5. To install, reverse the removal procedure.
    • Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test in this section.

Test yourself

A quick Ford Focus quiz: every answer comes with an explanation and a link to the manual page.