Seat Backrest Cover - Rear

Push the buttons on the head restraint guides and remove the head restraint(s).

NOTE: If the locking tab on the head restraint guide is damaged during removal, a new head restraint guide must be installed.

Remove the head restraint guides.

• Insert an appropriate flat-blade screwdriver along side the head restraint guide below the backrest cover and release button.

• Release the locking tab and pry upward to remove.

Release the lower J-clip and hook-and-loop strip.

NOTICE: Use care when separating the backrest trim cover from the hook-and-loop strips, or the hook-and-loop strips can be torn from the backrest foam pad.

Invert the backrest cover and remove the row of hog rings.

Invert and remove the backrest cover.

• Route the latch release strap through the backrest cover opening.

To install, reverse the removal procedure.