Caution Do not place objects or install equipment on or near the airbag cover, on the side of the front seatbacks, or in areas of the front seats that may contact airbag deployment. Failure to follow these instructions may increase the risk of personal injury in a crash.
Do not secure antenna cables to the vehicle's original wiring, fuel lines or brake lines.
Keep antenna and power cables at least 4 inches (10 cm) away from any electronic modules and airbags. Note: We test and certify your vehicle to meet electromagnetic compatibility requirements (UN ECE Regulation 10 or other applicable local requirements). It is your responsibility to ensure that any equipment installed on your vehicle by an authorized dealer complies with applicable local laws and other requirements.
NOTE Any radio frequency transmitting equipment in your vehicle (such as cellular telephones and amateur radio transmitters) must comply with the parameters in the following table. We do not provide special provisions or conditions for installations or use.
Car
Van
Truck
NOTE After installing a radio frequency transmitter, check for interference from all electrical equipment in your vehicle, in both standby and transmit modes.
Check all electrical equipment:
With the ignition on.
With the engine running.
During road tests at different speeds.
Make sure the electromagnetic fields generated in the passenger compartment of your vehicle by the installed transmitter do not exceed the applicable human exposure requirements.
