Light switch

1. 1
   Off
2. 2
   Side and tail lights
3. 3
   Headlights

High beams

Pull the lever towards you to turn on the high beams.

Pull the lever towards you to turn off the high beams.

High beam flash

Pull the lever gently towards you and release it to flash the high beams.

Parking lights

Note: Prolonged use of the parking lights with the ignition off may discharge the battery.

To turn on the parking lights, rotate the light switch to position B. The parking lights operate with the ignition on or off.

One side

1. 1
   Turn off the ignition.
2. 2
   Turn the light switch to the OFF position.
3. 3
   Make sure the turn signal lever is in the centre position.
4. 4
   Move the turn signal up or down as required.

   

5. 5
   Right-hand side
6. 6
   Left-hand side

Delayed headlight switch-off

After switching off the ignition, the headlights can be turned on by pulling the turn signal lever towards you. A short audible signal will sound. The headlights will switch off automatically after three minutes when a door is opened, or 30 seconds after the last door is closed. This function can be cancelled by pulling the turn signal lever towards you again or by switching on the ignition.

Daytime running lights

DANGER

The daytime running light system does not activate the tail lights and may not provide adequate illumination in poor visibility conditions. Make sure the headlights are turned on as required in poor visibility conditions. Failure to follow this instruction may cause accidents.

The system turns on the daytime running lights in daylight conditions.

To activate the system:

1. 1
   Turn the ignition on.
2. 2
   Turn the light switch to OFF or to the parking light position.