Ford Mondeo Quiz
Maintenance

Headlamp Removal

In this manual: Maintenance
Introduction — 9Overview — 6Child safety — 5Seat belts — 4Supplemental Restraint System — 8Keys and Remote Controls — 4MyKey — 9Locks — 3Safety — 4Steering wheel — 6Wipers and washers — 4Lighting — 15Windows and mirrors — 7Instrument cluster — 4Information Displays — 3Climate control unit — 9Seats — 10Auxiliary power points — 1Storage Compartments — 4Engine Starting and Stopping — 7Unique Driving Characteristics — 1Fuel and Refueling — 7High-voltage battery — 3Transmission — 1Brakes — 5Traction control — 3Electronic Stability Control — 3Parking Aids — 7Cruise control — 4Driver assistance — 21Vehicle Loading — 1Towing — 3Driving tips — 6Roadside assistance in emergencies — 11Fuses — 3Maintenance — 15Vehicle Cleaning — 6Wheels and Tires — 8Capacities and specifications — 3Audio system — 8SYNC — 7SYNC 2 — 10Appendices — 3
7steps
~42min
2/5difficulty
Done 0 of 7
Dépose d'un phare

Note: To remove the retaining pins, use a flat-blade screwdriver to lift the central release pins.

  1. Make sure the headlamp control is in the off position, then open the hood.
  2. Remove the six retaining pins securing the front trim strip to the front trim panel.
  3. Remove the three upper bumper cover screws using a flat-blade screwdriver.
  4. Remove the retaining pin located inside the headlamp being repaired.
    Dépose d'un phare

  1. Remove the two headlamp retaining screws using a flat-blade screwdriver.
Dépose d'un phare

  1. Remove the three lower wheel housing fasteners by turning them counterclockwise.
Dépose d'un phare

  1. Remove the two outermost lower front bumper cover fasteners, on the headlamp side being replaced only, by turning them counterclockwise.
Dépose d'un phare

  1. Separate the front bumper cover from the fender by gently pulling the front bumper cover outward, away from the vehicle, by 1.2 inches (3 centimeters).
Dépose d'un phare

  1. From the front of the vehicle, gently pull the front bumper cover out by 4 inches (10 centimeters), holding it beside the headlamp being replaced and at the front, at the bottom of the wheel opening.
Dépose d'un phare

  1. Gently pull the headlamp lens outward to release it from the lower mounting point.
  2. Carefully lift the headlamp and remove it from the vehicle.
  3. Disconnect the headlamp lens connector by pressing the connector tab.

Test yourself

A quick Ford Mondeo quiz: every answer comes with an explanation and a link to the manual page.