Installation

1. NOTE: The LH side is shown, and the RH is similar.

Install the supply manifold and tighten the four bolts.

2. Connect the EGR vacuum line.

3. Install the EGR to exhaust manifold tube. For additional information, refer to Section.

4. NOTE: The engine is removed for clarity.

Position the EVR bracket and tighten the bolts.

5. Connect the EVR solenoid vacuum lines.

6. Connect the LH fuel injector electrical connectors.

7. Connect the ground wire.

8. Connect the fuel pressure sensor electrical connector and the vacuum hose.

9. NOTE: Make sure the locking clips are fully engaged into the bracket.

Reposition the accelerator cable and the speed control cable (if equipped) and install the cables into the bracket.

10. Connect the hose.

11. Connect the IAC electrical connector and install the main chassis vacuum hose.

12. Connect the four RH fuel injector electrical connectors.

13. Connect the PCV hose.

14. Position the IAC hose and connect the hose.

15. Install the throttle body.

16. Connect the fuel line.

17. Connect the air cleaner outlet tube.

18. Connect the battery ground cable.