Honda Fit Quiz
Second generation (2007-2026)

CMP Pulse Plate Removal and Installation

In this manual: Second generation (2007-2026)
First generation (2001–2008) — 118Second generation (2007-2026) — 923
16steps
~96min
4/5difficulty
Done 0 of 16
Removal

  1. Remove the air cleaner.

  2. Remove the intake manifold chamber.

  3. Disconnect the following engine wire harness connectors, and remove the wire harness clamps from the cylinder head:

    • Four injector connectors

    • ECT sensor 1 connector

    • CMP sensor connector

    • A/F sensor connector

    • Secondary HO2S connector

  4. Remove the harness holder mounting bolt and the ground cable, then remove the harness holder from the bracket.

  5. Remove the cylinder head cover.

  6. Remove the camshaft thrust cover (A).


  1. Hold the camshaft with an open-end wrench, then loosen the bolt.

  2. Remove the CMP pulse plate (A).

Installation

  1. Install the CMP pulse plate (A).

  2. Hold the camshaft with an open-end wrench, then tighten the bolt.

    Specified Torque

    14 x 1.5 mm

    34 NВ·m (3.5 kgfВ·m, 25 lbfВ·ft)

  3. Install the camshaft thrust cover (A) with a new O-ring (B).

  4. Install the cylinder head cover.

  5. Install the harness holder, then install the ground cable.

  6. Connect the following engine wire harness connectors, and install the wire harness clamps from the cylinder head:

    • Four injector connectors

    • ECT sensor 1 connector

    • CMP sensor connector

    • A/F sensor connector

    • Secondary HO2S connector

  7. Install the intake manifold chamber.

  8. Install the air cleaner.

Test yourself

A quick Honda Fit quiz: every answer comes with an explanation and a link to the manual page.