Engine Room Fuse Panel Fuse Replacement

■ Blade Fuse

■ Cartridge Fuse

1. Turn off the engine.

2. Turn off all other switches.

3. Remove the fuse panel cover by pressing the tab and pulling up.

4. Check the removed fuse; replace it if it is blown. To remove or insert a fuse, use the fuse puller in the engine room fuse box.

5. Insert a new fuse of the same rating and make sure it fits firmly into the clips. If it does not fit firmly, contact an authorized HYUNDAI dealer.

CAUTION

After inspecting the engine room fuse box, securely close the fuse box cover inside the engine compartment until it clicks.

If the fuse box is not properly closed, water may enter, which may cause a malfunction in the electrical system.

Main Fuse

If the main fuse is blown, remove it as follows:

1. Turn off the engine.

2. Disconnect the negative battery cable.

3. Remove the fuse panel cover by pressing the tab and pulling it upward.

4. Remove the nuts shown in the illustration above.

5. Replace the fuse with a new one of the same rating.

6. Install in the reverse order of removal.

Information

If the main fuse is blown, contact an authorized HYUNDAI dealer.

Multi Fuse

If the multi fuse is blown, remove it as follows:

1. Turn off the engine.

2. Disconnect the negative battery cable.

3. Remove the fuse panel cover by pressing the tab and pulling it upward.

4. Remove the nuts shown in the illustration above.

5. Replace the fuse with a new one of the same rating.

6. Install in the reverse order of removal.

Information

If the multi fuse is blown, contact an authorized HYUNDAI dealer.